DEFORM-3D有限元铝合金拔长变形过程应变场分布的研究
关键词: 拔长；铝合金；网格法；应变场；数值模拟
The Study of Aluminium alloy with strain field after drawing out the deformation process
Abstract: Based on DEFORM 3d finite element analysis software on 6061 aluminum alloy long pull deformation in the process of the distribution of strain field are studied, under different reduction obtained distribution of compressive strain nephogram and contour map. Analysis of process conditions on the influence of the strain field distribution inside the billet, given the laws of strain field distribution. Simulation results, the author found out that, in the process of aluminum alloy billet asymmetric long pull first produces plastic deformation at the center of the billet, billet parts begin to form sag under the pressure, the lateral bulging, compressive strain near the compressive stress first, then the strain value increases gradually, at the bottom of the axis of symmetry of the peak near the center. With the increase of deformation degree, maximum strain value increase. And then using the grid method of experiments have been carried out to verify the rationality of the results of numerical simulation, respectively, on the center line of compressive strain distribution and the strain field distribution is verified, the results prove the feasibility of simulation and accuracy. Finally respectively using Gaussian function, the cauchy - lorentz function and Vogit functions on the symmetric axis compressive strain distribution fitting, the fitting results show that the long pull deformation process, the billet internal strain distribution can be used to express the function.
Keywords: Stretching; aluminium alloy；mesh method；strain field；numerical simulation
目录
1.绪论 5
1.1 铝合金 5
1.1.1合金发展现状与趋势 5
1.1.2 6061铝合金在不同变形条件下的应力应变曲线 6
1.2拔长工艺的研究进展 7
1.3 网格法 8
1.3.1网格法的基本原理 8
1.3.2网格法的确定 9
1.4 有限元模拟技术在变形应变场中的应用 9
1.4.1有限元模拟的发展现状及应用 9
1.4.2有限元模拟对拔长应变分布的意义 10
1.5选题的目的和意义 10
1.6课题的研究内容 11
2 金属塑性成形工艺有限元数值模拟技术 12
2.1 引言 12
2.2 金属塑性成形模拟中关键技术 12
2.2.1 模具结构的数学描述 12
2.2.2摩擦边界条件处理 13
2.2.3动态接触边界处理 13
2.2.4网格划分和重划分的处理 13