摘要:选用天然矿物凹凸棒石为吸附剂载体,将聚乙烯亚胺浸渍到载体上,制备新型CO2吸附剂,考察改性剂种类、负载量、吸附温度等对CO2吸附性能的影响。结果表明,聚乙烯亚胺(PEI, Mw=1800。99%)改性后的凹凸棒石对CO2吸附量大于聚乙烯亚胺(PEI, Mw=600。99%)改性凹凸棒石;随PEI的负载量增大,吸附剂对CO2吸附性能增大,当负载量为60%,吸附温度为60℃时,CO2吸附量达到了1。2376mmol/g;随吸附温度的升高吸附容量先增加后减小,60 ℃时CO2吸附量最大;经硅烷偶联剂KH550改性的吸附剂要比未改性的吸附剂吸附性能好;当水分存在时,吸附性能有显著提高。经5次吸/脱附循环后,吸附量没有明显降低,表现出较好的循环稳定性。94846

毕业论文关键词:凹凸棒石;聚乙烯亚胺;二氧化碳;吸附 

ABSTRACT: The natural mineral attapulgite was used as the adsorbent carrier, and the polyethylene imine was impregnated into the carrier to prepare the new CO2 adsorbent。 The effects of modifier type, loading capacity and adsorption temperature on the adsorption performance of CO2 were investigated。 The results showed that the amount of CO2 adsorbed by polyethyleneimine (PEI, Mw=1800。99%) modified attapulgite was higher than that of  (PEI, Mw=1800。99%)  Modified Attapulgite 。The adsorption capacity of CO2 increases with the increase of PEI loading。 When the amount of loading is 60% and the adsorption temperature is 60 DEG C, the amount of CO2 adsorption reaches 1。2376mmol/g。 the adsorption capacity increases first and then decreases with the increase of adsorption temperature, the adsorption capacity of CO2 was the largest at 60 centigrade。 The adsorbent modified by silane coupling agent KH550 has better adsorption properties than unmodified adsorbent 。 When the moisture content exists, the adsorption performance is improved remarkably。 After 5 adsorption-desorption cycles , amines functionalized palygorskite has not noticeable decrease in CO2 adsorption capacity which displays excellent regenerability and stability。

Keywords:Attapulgite, Polyethyleneimine,CO2,Adsorption 

目录

1  前言 5

1。1  常用CO2分离方法 5

1。1。1  吸收法 5

1。1。2  膜分离法 6

1。1。3  生物分离法 6

1。1。4  吸附法 6

1。2  CO2吸附剂研究进展 7

1。2。1  碳基吸附剂 8

1。2。2  沸石类吸附剂 8

1。2。3  金属氧化物 8

1。3  吸附材料表面改性方法 8

1。4  凹凸棒粘土概述和性能 9

1。4。1  凹凸棒粘土概述 9

1。4。2  凹凸棒粘土性能 10

1。5  本文研究目的及内容 11

1。5。1  研究目的 11

1。5。2  研究内容 11

2。1  实验部分 11

2。1。1  实验药品与仪器 11

2。2  吸附剂制备 12

2。2。1  采用浸渍法将聚乙烯亚胺负载到凹土上 12

上一篇:基于多氮配体Cd(II)离子及间苯二酸的配位聚合物的合成结构及荧光性质研究
下一篇:常压室温等离子体ARTP诱变筛选羰基还原酶高产菌株

介孔二氧化硅载药微囊表面磁性修饰

遮光性白色聚酰亚胺薄膜的制备与性能

异氰酸乙酯修饰凹凸棒土...

石墨相氮化碳聚乙烯醇复合膜的制备与表征

聚乙烯醇氮化碳复合渗透...

三-[2-亚胺基-(3′-甲基吡啶)]胍的合成及表征

三-[(2′-亚胺基-5′-硝基...

《水浒传》中血腥暴力研...

高效课堂教师问卷调查表

从企业eHR建设谈管理信息...

遥感土地用变化监测国内外研究现状

PCI+PID算法直流力矩电机速...

提高小學语文課堂朗读教...

MNL模型历史城区居民活动...

大规模MIMO系统的发展研究现状

小型通用机器人控制系统设计任务书

浅析施工企业保理融资成...