摘要本文提出了在分组交换网络中用于拥塞避免的随机提前检测(RED)网关。网关通过计算平均列队长度检测早期的拥塞。网关可以通过丢弃到达网关的数据包或通过设置数据包头的一个位来通知连接发生了拥塞。当平均队列长度超过预先设定的阈值时,网关以一定的概率丢弃或标记每个到达的数据包,其概率是平均队列长度的函数。65335

RED网关保持低的平均队列长度,同时允许队列中偶尔的突发的分组。在拥塞发生时,网关通知一个特定的连接来减少其窗口的概率与通过网关的带宽和连接的份额大致成正比。RED网关的目的是辅助一个传输层的拥塞控制协议(如TCP)。RED网关没有偏见的突发性流量,避免了与全球同步的连接,同时降低了窗口的数量。RED网关的性能可以通过使用TCP / IP的网络模拟来说明。

毕业论文关键词  RED网关    拥塞    

毕业设计说明书(论文)外文摘要

Title   The Comparison of RDE and Droptail                           

Abstract This paper presents Random Early Detection (RED) gateways for congestion avoidance in packet-switched networks.The gateway detects incipient congestion by computingthe average queue size. The gateway could notify connections of congestion either by dropping packets arriving at the gateway or by setting a bit in packet headers. When the average queue size exceeds a preset threshold,the gateway drops or marks each arriving packet with a certain probability, where the exact probability is a function of the average queue size.

RED gateways keep the average queue size low while allowing occasional bursts of packets in the queue. During congestion, the probability that the gateway notifies a particular connection to reduce its window is roughly proportional to that connection’s share of the bandwidth through the gateway. RED gateways are designed to accompany a transport-layer congestion control protocol such as TCP.The RED gateway has no bias against bursty traffic and avoids the global synchronization of many connections decreasing their window at the same time. Simulations of a TCP/IP network are used to illustrate the performance of RED gateways.

Keywords  RDEgateway     congestion avoidance

目录

1  引言 5

2  目前国内外对于网络拥塞的研究概况 6

3  互联网拥塞控制相关研究 8

3.1 基本概念 8

3.2 互联网拥塞控制机制 11

4  RED算法和Droptail算法 11

4.1  Droptail算法 12

4.2  RED算法 12

5  NS2仿真平台设计 14

5.1  仿真软件NS-2的简单介绍 14

5.2  NS-2下的仿真设计 16

结论 22

致谢 23

参考文献 24

1  引言

随着Internet本身规模的迅速扩大、Internet用户数的剧增、以及网络应用类型的快速增加,网络正经历越来越多的包丢失和其他的性能恶化问题,其中一个比较严重的现象就是网络拥塞。 

网络拥塞(congestion)是指在分组交换网络中传送分组的数目太多时,由于存储转发节点的资源有限而造成网络传输性能下降的情况。网络拥塞导致的直接后果是整个网络的性能下降:包括分组丢失率增加、端到端延迟增大、网络吞吐量下降、甚至有可能使整个系统发生拥塞崩溃。当网络处于拥塞崩溃状态时,微小的负载增量都将使网络的有效吞吐量急剧下降。 造成网络拥塞的原因很多,主要有:存储空间不足、带宽容量不足、处理器处理能力弱、TCP/IP协议拥塞控制机制中的缺陷、用户的恶意攻击造成的网络拥塞、以及网络系统的混沌、分叉等现象都会导致网络通讯的崩溃。 论文网

上一篇:Wilkinson功率分配器宽带功分器设计
下一篇:AQM算法中的RED与REM仿真比较

基于TCP/IP技术的转向架振动测试系统设计

基于PM2.5浓度的健康出行路径规划及实现

基于涡旋电磁波的新型雷达成像技术研究

基于相关滤波器的长期跟踪算法研究

基于ZigBee协议轨道交通环...

变分模态分解方法研究及...

HFSS形状渐变方法的槽缝加载微带天线设计

《水浒传》中血腥暴力研...

PCI+PID算法直流力矩电机速...

MNL模型历史城区居民活动...

从企业eHR建设谈管理信息...

大规模MIMO系统的发展研究现状

提高小學语文課堂朗读教...

小型通用机器人控制系统设计任务书

浅析施工企业保理融资成...

遥感土地用变化监测国内外研究现状

高效课堂教师问卷调查表