摘要:本文的主要研究方向是复掺粉煤灰和矿渣作为混凝土的掺合料。通过正交实验方案进行胶沙实验,研究最佳的砂率、水胶比、粉煤灰矿渣最大掺量、粉煤灰矿渣的比例三个影响对胶沙强度影响。再通过平行对比实验找出矿渣与粉煤灰两者复掺合适的比例,分析粉煤灰矿粉双掺胶沙体系的水化特点和强度发展规律。并在此基础上配置粉煤灰和矿粉双掺高性能混凝土。对混凝土试块7天、28天、56天的抗压能力测试,通过扫描电镜观察28天养护混凝土内部的水化情况。研究表明粉煤灰和矿粉双掺的高性能混凝土,早期强度低,后期强度高,混凝土耐久性能好。在粉煤灰和矿粉总参量为40%,比例为1:3时的混凝土的强度发展最高。81787

毕业论文关键词: 混凝土;掺合料;力学性能

Study on Mix Proportion Design and Mechanical Properties of Lightweight High Strength Concrete Mixed with Reactive Material

Abstract:The main research direction of this paper is mixed with fly ash and slag as concrete admixture。 The effects of the three effects of the maximum sand rate, the ratio of water to cement, the maximum amount of fly ash slag and the ratio of fly ash slag on the strength of sand were studied by orthogonal experiment。 And then through the parallel comparison experiment to find the appropriate proportion of slag and fly ash mixed with the appropriate proportion of the analysis of fly ash ore powder mixed sand system of hydration characteristics and strength of the law。 And on this basis, the configuration of fly ash and mineral powder mixed with high performance concrete。 The compressive strength of the concrete was tested for 7 days, 28 days and 56 days, and the hydration of the concrete was observed by scanning electron microscopy for 28 days。 The research shows that the fly ash and slag mixed with high performance concrete, the early strength is low, the late strength is high, the concrete durability is good。The maximum strength of concrete is the highest when the total parameters of fly ash and slag are 40% and the ratio is 1: 3。

Key Words:concrete;blending material;mechanical property

目  录

1。 绪论 1

1。1 混凝土 1

1。1。1 混凝土的历史 1

1。1。2 高性能混凝土 1

1。2 掺合料 2

1。2。1 粉煤灰 2

1。2。2 矿粉 3

1。3 粉煤灰混凝土的现状 3

1。4 矿渣微粉混凝土的现状 4

1。5 本论文的研究思路 5

1。5。1 本文的目的和意义 5

1。5。2 本文研究的内容 5

2。 实验部分 6

2。1 实验原料及仪器设备 6

2。2 水泥胶砂试验 8

2。2。1 试验设计 8

2。3 平行对比实验 9

2。3。1试验方案设计 9

2。4 混凝土配合比设计 10

2。4。1 混凝土配比设计原则 10

2。4。2 轻质高强混凝土配合比设计 11

2。5 混凝土试块的制备 11

2。6 混凝土试块养护

上一篇:热轧酸洗搪瓷钢薄板强度对其拉深性能的影响
下一篇:介孔二氧化硅载药微囊表面磁性导向性修饰

高稳定性层状Birnessite-Li...

激光液相烧蚀法制备纳米材料过程与机理研究

网状结构Fe-Al基复合材料的制备及性能研究

透明电子材料和器件的制备

生物质纳米材料的结构和物理性能

新型二维材料的pso结构预测及性能计算

激光参数对液相激光烧蚀...

小型通用机器人控制系统设计任务书

PCI+PID算法直流力矩电机速...

高效课堂教师问卷调查表

从企业eHR建设谈管理信息...

提高小學语文課堂朗读教...

浅析施工企业保理融资成...

《水浒传》中血腥暴力研...

遥感土地用变化监测国内外研究现状

大规模MIMO系统的发展研究现状

MNL模型历史城区居民活动...