摘要:以水热法合成磁性铁酸锌为基体,采用水浴沉淀法在其表面原位沉积纳米氧化锌(ZnO),形成ZnFe2O4-ZnO复合光催化剂用于光催化降解间苯二酚。通过调节ZnFe2O4与ZnO的量合成一系列不同比例的ZnFe2O4-ZnO ( r=nZnFe2O4:nZnO=3:10,5:10,7:10,1:1,10:7,10:5,10:3,0)来寻找最优性能的复合催化剂。采用X-射线粉末衍射(XRD)、比表面积(BET)、扫描电子显微镜(SEM)、紫外可见紫外可见漫反射光谱(UV-Vis)等分析手段对产物进行了表征。结果表明,ZnO纳米粒子分布均匀在ZnFe2O4表面,二者复合效果好,具有磁分离特性。复合光催化剂显示出优异的光催化性能,而且比例不同对复合光催化剂的性能有明显影响:当r<1时,在r=5:10时显示出优异的光催化性能,110min内对50mg/L间苯二酚降解率达 87。45%,并且回收的催化剂也达到了较好的降解效果;当r>1时,在r=10:3 时显示出最优异光催化性能,3h时对间苯二酚的降解率高达94。33%。72596

毕业论文关键词:ZnFe2O4-ZnO,水热法,水浴沉淀法,磁性,间苯二酚

     

Abstract: In this article, ZnFe2O4 was firstly fabricated by hydrothermal method。 Then the nanocomposite photocatalyst was successfully synthesized by introducing ZnO onto the surface of ZnFe2O4 using bath deposition for the photodegradation of resorcinol under ultraviolet radiation (marked as ZnFe2O4-ZnO-r)。 To achieve the best performance of nanocomposite photocatalyst, the molar ratio of ZnFe2O4 and ZnO was adjusted to give a series of proportions r = nZnFe2O4/nZnO=3:10, 5:10, 7:10, 1:1, 10:3, 10:5 ,10:7 ,0 。 These obtained products were characterized by X-Ray diffraction (XRD), BET surface area and Scanning electron microscope (SEM) methods。 Results showed that ZnO particles were successfully loaded onto the surface of ZnFe2O4 and distributed uniformly。 Correspondingly, the composite photocatalyst presented the characteristic of magnetic separation。 It was found that ZnFe2O4-ZnO showed excellent photocatalytic activity and different proportion of r has obvious effects on photocatalytic efficiency。 When ZnFe2O4-ZnO-r<1, the highest degradation rate of 50mg/L resorcinol was 87。45% within 110 min in the case of r=3:10。 The repeated use of the composite photocatalyst was also confirmed well。 When ZnFe2O4-ZnO-r>1, ZnFe2O4-ZnO with r = 10:3 showed the excellent photocatalytic performance and the degradation rate reached to 94。33% within 3 hours。

keywords: ZnFe2O4-ZnO , hydrothermal method , bath deposition, magnetic, resorcinol

目  录

1 引言 1

2  实验部分 2

2。1实验原料 2

2。2 实验仪器 2

2。3 复合光催化剂的制备 3

2。4 材料表征 3

2。5 材料的光催化性能 4

3 实验结果 4

3。1 催化剂的表征 4

3。1。1 XRD分析 4

3。1。2 BET分析 5

3。1。3 UV-Vis DRS分析 6

3。1。4 SEM 分析 7

3。2 不同比例催化剂的光催化性能研究 8

结论 11

参考文献 12

致  谢 13

1 引言

    目前,随着生产生活的快速发展,有机化工产品的用量也越来越多,与此同时污染物的排放量也与日俱增,带来了环境形势严峻、生态环境面目全非、环境污染事故频发等问题,已经威胁到我国经济的可持续发展和公民的人身财产安全。论文网   

上一篇:新型功能高分子膜材料的研究进展
下一篇:小麦秸秆制活性炭用作超级电容器电极材料

不同前驱g-C3N4的制备及光催化性能研究

水样有机物的光催化降解及COD在线检测

多级结构复合电极材料的制备工艺研究

遮光性白色聚酰亚胺薄膜的制备与性能

二氧化锡纳米微球制备和光催化

油酸辅助水热法制备CaRE2(MoO4)4:RE3+荧光粉

BiVO4光催化剂的改性及其催化氧化性能研究

浅谈新形势下妇产科护理...

中国古代秘书擅权的发展和恶变

国内外无刷直流电动机研究现状

高校网球场馆运营管理初探【1805字】

《醉青春》导演作品阐述

浅谈传统人文精神茬大學...

拉力采集上位机软件开发任务书

多元化刑事简易程序构建探讨【9365字】

谷度酒庄消费者回访调查问卷表

辩护律师的作证义务和保...