2.    The problem of match the reference wavefront and the test wavefront in point diffraction interferometer was studied. The changes in light intensity were analysis comparatively with different hole diameter, defocus in lateral, the incident wavefront includeing aberrations. The simulation results showed that the smaller the hole diameter, the weaker the diffracted light intensity. For a given hole diameter, axial defocus in can adjust the contrast of interference pattern greatly, and lateral defocus can improve contrast to some extent. The transmission of point diffraction plate designed as 1/5 as the optimum transmission with no lateral defocus is reasonable. By using the property of the Fourier transform lens, a model was established with the point diffraction interferometer system regarded as 4f system, and the simulation results proved the defocusing effect on the contrast of the interference pattern.
3.    The experiment measured the emission wavefront by the holes diffracting. A experimental wavefront diffracted by a 10um diameter pinhole detection system were constructed, and comparing the detection results with the simulation, both PV deviation is 0.025, and RMS deviation is 0.052. Construction of the point diffraction interferometer measurement system verified that adjusting defocus can obtain a better contrast interferogram for the plates with a given transmission, and the diffraction points of different diameter. The wavefront was recovered from the interferogram by Fourier transform method, and the results matched with the measurements by SID4 wave detectors, which verified the feasibility of a point diffraction interferometer.
Keywords: Point diffraction interferometer, Wavefront detection, The reference wavefront, Diffraction intensity, Scalar diffraction
目    次
1    绪论    1
1.1    研究背景及研究意义    1
1.2    国内外的研究现状及发展趋势    2
1.3    课题来源和主要研究内容    9
2    点衍射干涉仪系统与分析理论    11
2.1    技术指标    11
2.2    主体光路设计    11
2.3    点衍射相关分析理论    12
2.3.1    矢量衍射分析法    12
2.3.2    标量衍射分析法    13
3    点衍射干涉仪系统参考光波前分析    17
3.1    衍射参考光波前质量分析    17
3.1.1    小孔直径偏差    17
3.1.2    小孔圆度偏差    18
3.1.3    小孔粗糙度偏差    19
3.1.4    小孔横向对准偏差    20
3.1.5    入射波前像差    22
3.2    参考光光强分析    25
3.2.1    光强匹配    25
3.2.2    小孔直径影响    27
3.2.3    横向离焦影响    27
3.2.4    像差影响    29
3.2.5    膜层厚度    30
3.3    本章小结    31
4    点衍射干涉仪的干涉图分析    33
4.1    透镜的傅里叶变换性质    33
4.2    4f系统模型    34
4.3    干涉图仿真    35
4.4    本章小结    36
5    点衍射干涉仪的实验研究    37
5.1    点衍射板小孔与10um针孔参数检测研究    37
上一篇:非均匀电场强化沸腾换热实验研究
下一篇:ZEMAX基于对称楔形干涉腔的高光谱成像方法研究

PbSe量子点的合成及光谱性质研究

ANSYS应用波浪能的海洋环境...

和隧穿量子点作用单模场压缩

激光作用下隧穿量子点的偏态信息

光的衍射和干涉现象及其仿真

共焦点聚焦形貌测量技术与应用研究

S度量空间中公共不动点问题的研究

上海居民的社会参与研究

酵母菌发酵生产天然香料...

STC89C52单片机NRF24L01的无线病房呼叫系统设计

浅谈高校行政管理人员的...

浅论职工思想政治工作茬...

AES算法GPU协处理下分组加...

提高教育质量,构建大學生...

从政策角度谈黑龙江對俄...

压疮高危人群的标准化中...

基于Joomla平台的计算机学院网站设计与开发