摘要本设计主要将太阳能与窗台窗帘进行结合,将硅光电池嵌入普通的百叶窗帘,研究并对比了硅光电池在不同倾斜角度下的太阳能吸收率,发现其吸收率的峰值所对应的角度会随时间而变化。据此现象,将两块硅光电池嵌入窗帘,连接窗帘至步进电机上,用西门子S7-200通过PLC编程对步进电机进行控制。每隔1小时检测一次硅光电池产生的信号,当产生的电压低于平均值时向控制器发送一个脉冲,使得步进电机驱动窗帘转动,以达到电池最佳的吸收角度。63657

毕业论文关键词  硅光电池  太阳能窗帘  步进电机  PLC

毕业设计说明书(论文)外文摘要

Title    Experimental study of solar curtains  controlled by PLC                                            

Abstract The design is based on the combining of solar and curtains. The silicon photovoltaic cells are embedded in ordinary blinds in this experiment. By studying and comparing the solar absorption rate of the silicon photovoltaic cells at different tilt angle, finding that the absorption rate corresponding to the peak angle change with time. According to this phenomenon, embedding  two silicon photocell into curtain and connecting this curtain to the stepper motor, then using Siemens S7-200 PLC programming to  control the stepper motor. Testing the voltage generated by silicon photovoltaic cells once 1 hour. If the voltage is lower than the average, PLC will give a pulse to the controller to make the stepper motor drive solar curtain rotating, and thus achieving optimum absorption of the cells.

Keywords  Silicon photocell  Solar curtain  Stepper motor  PLC

1  绪论 2

1.1  太阳能的概念及应用形式 2

1.2  太阳能的研究现状 3

1.2.1  各国对太阳能的政策 3

1.2.2  太阳能与其他应用结合的研究现状 3

1.3  本课题研究的问题 6

2  入射角的理论分析 7

2.1  最佳倾角的计算 7

2.1.1  直射辐射 7

2.1.2  散射辐射 8

2.1.3  地面反射辐射 8

2.2  各地区最佳倾角的分析 8

3  太阳能窗帘及步进电机的驱动设计 13

3.1  实验器材 13

3.1.1  硅光电池 13

3.1.2  步进电机 14

3.1.3  驱动器 16

3.1.4  PLC系统 19

3.2  实验流程 23

4  实验数据及处理 25

4.1  不同角度下硅光电池的输出电压 25

4.2  程序的编写 27

4.3  仪器的连接 31

4.4  程序的装载与运行 32

结  论 35

致  谢 36

参考文献

上一篇:基于切换系统方法的网络控制系统的建模与控制
下一篇:单片机平板导热仪控制器的设计+电路图

基于51单片机自动门智能控制系统设计

plc空压机循环冷却水自动...

PLC物料自动分拣系统的设计+源程序

软PLC技术电梯控制与实现+梯形图

粉料称重装置的单片机控...

太阳能电站的自动跟踪系...

STM32的4G太阳能电站监控系统设计+PCB电路图

《醉青春》导演作品阐述

国内外无刷直流电动机研究现状

多元化刑事简易程序构建探讨【9365字】

浅谈传统人文精神茬大學...

谷度酒庄消费者回访调查问卷表

高校网球场馆运营管理初探【1805字】

浅谈新形势下妇产科护理...

拉力采集上位机软件开发任务书

中国古代秘书擅权的发展和恶变

辩护律师的作证义务和保...