摘要: 本论文基于高层供水的要求,设计一个基于西门子S7-1200 PLC的变频恒压供水系统,该系统由可编程控制器核心、调速变频器、供水水泵机组、水压传感器等构成。其中,系统包括两组水泵机组,每组包括三台水泵电机,两台处于工频或变频运行,一台用作后备使用。两组水泵电机均采用变频器实现软启动和调速,且每组水泵电机的工作时间要求相同,自动运行时采用变频循环的运行方式,每组内水泵电机在运行切换时采用“先启先停”的原则。水压传感器负责将供水管网的水压信号反馈给PLC,经过PLC处理后通过控制变频器输出的电压和频率,来调节水泵电机的转速或加减运行中的水泵电机个数,进而改变水泵出水口处的流量大小,实现变频恒压供水。每组内的电机可以根据实际需求进行自动切换,也可以单独启动每个水泵电机,可以进行手动控制,便于后期对系统的维护和调试。71105

毕业论文关键词:恒压供水;变频器 ;PLC;软启动

Design of Soft Starter Base on PLC Water Supply System

Abstract: The high-level water supply based on the requirements of the design based on SIEMENS S7-1200 PLC frequency constant pressure water supply system, the system consists of a programmable controller, inverter, speed core water pumps, water pressure sensor. Among them, the system consists of two sets of water pump units, each group consists of three pump motors, two units in power frequency or frequency conversion operation, and one is used as back-up. Two sets of pump motor adopts frequency converter to realize the soft start and speed, and each pump motor working time requirements are the same, the automatic operation operating mode with frequency conversion cycle, each pump motor adopts "start first stop first" principle in the operation of switching. The pressure sensor will be responsible for the water supply network hydraulic pressure signal feedback to the PLC, after the processing of the PLC through the inverter output voltage and frequency control, the number of pump motor speed or operation to adjust the pump motor and the outlet of the water pump, and then change the size of the flow of the constant pressure water supply. The motors in each group can be switched automatically according to the actual demands, and each pump motor can also be started separately. The manual control can be carried out to facilitate the maintenance and debugging of the system in the later stage.

Keywords: Constant Pressure Water Supply; Frequency Converter; PLC; Soft Start

目录

摘要 ii

Abstract iii

目录 iv

1 绪论 1

1.1 课题的研究背景和意义 1

1.2 变频恒压供水概论 1

1.3 变频恒压供水的发展现状 2

1.4 本论文主要设计内容 3

2 变频恒压供水系统的相关理论分析 4

2.1 水泵的工作原理 4

2.1.1 离心泵的结构 4

2.1.2 离心泵的工作原理

上一篇:PLC除氧器控制系统设计
下一篇:java办公自动化系统设计与实现

基于Kinect手势识别的遥操...

冷库GPRS的无线数据采集系统设计

基于51单片机自动门智能控制系统设计

STC89C52单片机智能温度监测系统设计

plc空压机循环冷却水自动...

PLC物料自动分拣系统的设计+源程序

软PLC技术电梯控制与实现+梯形图

大规模MIMO系统的发展研究现状

PCI+PID算法直流力矩电机速...

浅析施工企业保理融资成...

从企业eHR建设谈管理信息...

小型通用机器人控制系统设计任务书

提高小學语文課堂朗读教...

MNL模型历史城区居民活动...

《水浒传》中血腥暴力研...

遥感土地用变化监测国内外研究现状

高效课堂教师问卷调查表